Customizing Template Instructions
If your knobs are not 2.25 or 3.0 inches left edge to left edge then you have to use the customizing template.
Place a piece of clear transparent tape on the rectangle that says Tape for easy adjustment.
Cut the template along the lines
to get a
two-piece template.
Slide the left side angle line over the neck of the left knob.
You may have to fold the edge of the template if it is rubs against the neck of the right knob.
Place the right side of the template on the neck of the right knob.
Line up the top edges of the two
templates and then tape them together.
Test the template to make sure it falls over the right knob neck easily
with no rubbing.
If there is rubbing adjust the two pieces and re-tape.
Now follow the tracing and cutting directions. Click Tracing.
Thank you for buying the easiest and most economical solution to protecting your glasses and dishware.
If you think this is complicated, spend $20 per pair of doors and get out your hammer, power drill and screwdrivers.
Quake Latch costs a tiny fraction of the cost of mechanical latches and is easier to install.
If you wish, we will custom cut latches for $25.00 for ten latches.
You can order them over our website:
Visitors: